Universal Relay Controller Equipped

(Radio Wide, Universal Relay Controller)

HGDefinitionMob.jpgKeyStoneButton.gifTutorialButton.gif

ENABLE.jpg Enables the radio to detect the connection of a Universal Relay Controller (URC) during radio power-up and normal operation. DotYellow.png If enabled and the URC is not connected at power-up, or is disconnected while the radio is on, a temporary error message is shown in the display. This feature applies on a radio-wide basis.

Disabled.jpg When disabled, the radio does not check for a connection to the URC, and no visual or audible alerts are issued. DotYellow.png Select this setting only if the normal radio installation does not include connection to a URC.

HGWorkflowNote.jpg

 

When a radio comes factory-equipped with an O7 Control Head that has the optional Siren and Lights Keypad, this feature's default value is "Enabled". See also the O7 Siren / Lights Keypad Keystone Concept.

HGWorkflowNote.jpg

 

WFForward.png Configuring up to 25 different relay patterns is possible. A specific Relay Pattern is then radio-user activated with the corresponding DotRed.png Relay Pattern button-press. DotGreen.png Once activated, pressing the button again deactivates the Relay Pattern; this also applies to the Directional Buttons.

 

WFForward.png Alternately, a Relay Pattern action may be included in a Consolidated Action which is then radio-user activated with an DotRed.png Action Consolidation button-press or Response Selector position.

DotGreen.png  When a Consolidated Action is active, pressing the Action Consolidation button again does not deactivate any of the actions; instead, it reactivates the sequence of actions, including the Relay Pattern; therefore, a separate Consolidated Action must be programmed that turns all Relay Patterns, Siren tones, GPS Reports, Mode changes and Direct Status to an "Unassigned" or Disabled state.

HGAccessedOnly.jpg

When the radio is model / option capable, and...

IconSmallWarning.png

For a Dual Radio configuration:

  • When the Radio Selection field is set to "Secondary Radio", this field must be "Disabled", otherwise it is considered invalid. "Disabling" this field then makes it inaccessible.

  • Although the URC hardware must be connected to the Primary Radio, and only the Primary Radio processes the CPS-defined relay patterns, the radio-user can still activate / deactivate these relay patterns independent of the current radio selection, provided the corresponding DotRed.png Relay Pattern button-presses are configured identically for both radios; additionally, an active relay pattern does not change state when the radio selection is swapped.

GoArrow.jpg

Go to the Universal Relay Controller Page